UPIM

[moskadondre]

Hi bugwiskers,
Thank you for your answer and thank you for the project.
I cannot read some values:post:262: RN1,R3,R6,R10,R11,R12 potR1
post 55:coil amp: C7; DR1 or 2
post 69:sampler 1: IC4
How i must connect the motherboard with  Atmega 644
     and the BOM:post 262
and the coil ampli:post 55
     and 64 sampler:post 69
and discrim board:post 213

where i can put push botton or encoder.

I'm lost with all the board and i would like make one who works;i thank you very much for your help.
Best regards.

[bugwhiskers]

Hi moskadondrem,

That post was around 4 and a half years ago, a lot has changed since then (including my memory).
I suggest you build one of the Hammerhead designs, they are a very good learning tool and there is lots of support available.

regards
bugwhiskers